Film cooling machine

Annular film cooling machine

scope of supply

Access Device	1 set
Compression device	1 set
Printing device (double printing wheel)	1 set
Isolation agent coating device (main and auxiliary water tanks)	1 set
Lifting device	1 set
Hanging glue cooling and conveying device	1 set
air cooling system	1 set
1st floor rear (or front) film output device	1 set
Output lateral swing device	1 set
Rubber swinging device	1 set
Rubber frame rotating device	1 set
electrical control system	1 set
Pneumatic Control	1 set

Online consultation

Main performance parameters and technical requirements

Device body color:

Power cabinet/control cabinet color:

Color of safety protection device:

Equipment layout: left-handed circular layout (facing the entrance end and looking towards the receiving end)

Total length of equipment:

From the inlet end of the receiving device to the outlet end of the swinging device in the middle position: 15m

Film width: ≤ 600mm

Film thickness: 8-12mm

Film adhesive length: maximum 1300mm (adjustable)

Hanging rod chain spacing: 127mm

Receiving uphill conveyor belt line speed: 35m/min (50HZ)

Adhesive discharge temperature: not higher than 5 ° C at room temperature

The adhesive film needs to be kept completely dry

Power supply: 380V ± 10% 50Hz three-phase five wire, 220V+10% 50Hz

undefined